Installation Procedure
Install the ignition coil (s) (2).
- Install the ignition coil bolt (s) (1).
Tighten
the bolt (s) to 10 N.m (89 lb in)
Connect the engine wiring harness electrical connector (s) (1) to the ignition coil (s) (2).
- For cylinder #4, connect the charge air cooler inlet pipe (left) to the charge air cooler cover. Refer to Charge Air Cooler Inlet Pipe Replacement - Left Side (LF3) .
- For cylinder #6, connect the charge air bypass valve-left side LF3, to the charge air cooler inlet pipe-left side. Refer to Charge Air Bypass Valve Replacement - Left Side (LF3) .
- Install the intake manifold cover-LF3. Refer to Intake Manifold Cover Replacement (LF3) .
CAUTION:
Refer to Fastener Caution .