Installation Procedure
Install the ignition coil (s) (2).
- Install the ignition coil bolt (s) (1).
Tighten
the bolt (s) to 10 N.m (89 lb in)
Connect the engine wiring harness electrical connector (s) (1) to the ignition coil (s) (2).
- For cylinder number 3 coil replacement, connect the charge air cooler inlet pipe (right) to the charge air cooler cover. Refer to Charge Air Cooler Inlet Pipe Replacement - Right Side (LF3) .
- For cylinder number 1 coil replacement, connect the charge air bypass valve-right side LF3 to the charge air cooler inlet pipe right LF3. Refer to Charge Air Bypass Valve Replacement - Right Side (LF3) .
- Install the air cleaner outlet resonator-LF3. Refer to Air Cleaner Outlet Resonator Replacement (LF3) .
CAUTION:
Refer to Fastener Caution .