Removal Procedure
NOTE:
High pressure fuel feed pipes are one time use only. ALWAYS install a NEW high pressure fuel feed pipe if the pipe is removed OR the fittings are loosened.
- Fuel Injection Fuel Rail Assembly - Bank 2 - Remove - Fuel Injection Fuel Rail Assembly Replacement - Bank 2 (LF3)
Remove the bank 1 fuel injection fuel rail fasteners (1).
- Disconnect the fuel rail electrical connector (2) and remove it from the fuel feed pipe bracket retainer (3).
Use the EN-49248 - 4 hooks (1) to slowly work the fuel injection fuel rail (2) upwards in small, even increments.
- Once the fuel injection fuel rail (2) is free, remove the EN-49248 remover components (1).
Slide the fuel injection fuel rail (1) toward the rear of the engine approximately 25 mm (1 in) and remove it from the vehicle.
- Once the fuel injection fuel rail is removed, clean and inspect the fuel injectors. Fuel Rail and Injectors Cleaning and Inspection (LF3)
NOTE:
Whenever ANY fuel injector is removed from the cylinder head or the fuel injection fuel rail, the fuel injector MUST be rebuilt.