Rocker Panel Molding Replacement

Callout	Component Name
Preliminary Procedures Tire and Wheel Removal and Installation (With J64)Tire and Wheel Removal and Installation (With J55) Open the front and rear side doors.
1	Front Wheelhouse Liner Bolt[2x] CAUTION: Refer to Fastener Caution . Tighten 2.5 N.m (22 lb in)
2	Rear Wheelhouse Liner Bolt[4x] Tighten 2.5 N.m (22 lb in)
3	Rocker Panel Molding Procedure Using the appropriate tool, release the retainers from the bottom edge and pull down the rocker panel molding from the body side outer panel. Using the appropriate tool, release the retainers from the top edge, pull out the rocker panel molding from the body side outer panel and remove from the vehicle. Close the front and rear side doors.