LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2018 >> XTS Livery >> Repair and Diagnosis >> Accessories & Equipment >> Interior/Illumination Lights >> Lighting System - Repair Instructions >> Repair Instructions >> Headlamp LED Driver Module Replacement (Daytime Running Lamp/Turn Signal)

Headlamp LED Driver Module Replacement (Daytime Running Lamp/Turn Signal)

GM4807308
Callout Component Name
Preliminary Procedure 
Headlamp Replacement 
1 Headlamp LED Driver Module Bolts (Qty: 3)
CAUTION:

Refer to Fastener Caution .

NOTE:

There are two LED Drivers mounted on each headlamp housing. There is a smaller one that is mounted on the inboard side of the headlamp facing the centerline of the vehicle. This one is the for daytime running lamp (DRL) and the park/turn signal lamp. There is a larger LED Driver mounted on the bottom of the headlamp. This one is for the high beam and low beam headlamp. When servicing the LED Driver, be sure to identify the correct component.


Tighten 
2.5 N.m (22 lb in)
2 Headlamp LED Driver Module
Procedure 
Disconnect the electrical connector.