Manual Shift Shaft and Seal Replacement

Preliminary Procedures

1. Remove the battery tray. Refer to Battery Tray Replacement .
2. Remove the manual shaft and position switch assembly. Refer to Manual Shift Detent Lever with Shaft Position Switch Assembly Replacement .

• For seal removal use J 45201  Cooler Line Seal Remover.
• For seal installation use J-46626  Seal Installer.
• Lubricate the manual shaft with automatic transmission fluid (ATF) to prevent damage to the manual shift shaft seal.

Special Tools

• J 45201  Cooler Line Seal Remover
• J-46626  Seal Installer