LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2018 >> XT5 Base, FWD >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Restraint System >> Repair Instructions >> Steering Wheel Airbag Replacement

Steering Wheel Airbag Replacement

GM4297435
Callout Component Name
WARNING:

Refer to SIR Warning .

WARNING:

Refer to SIR Inflator Module Handling and Storage Warning .

Preliminary Procedure Disable the SIR system. SIR Disabling and Enabling 
1 Steering Wheel Airbag
WARNING:

After installation of the steering wheel airbag module to the steering wheel, slightly pull the module outward. If there is no give on the airbag module then it is secured correctly. If the airbag module is not fully attached personal injury could result.

Procedure

  1. Fully Insert a small screwdriver or equivalent tool into access holes on the rear left and right side of the steering wheel.
  2. Apply and keep constant pressure on handle towards front of vehicle to push the spring fastener inward to release the steering wheel airbag from the steering wheel.
  3. Release the connector position assurance (CPA) retainer.
  4. Disconnect the electrical connectors.
  5. Inflatable Restraint Module Handling and Scrapping (Europe) Inflatable Restraint Module Handling and Scrapping (Except Europe) 
  6. Enable the SIR System. SIR Disabling and Enabling 
scientia non olet · About LEMON Manuals