LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2018 >> XT5 Base, FWD >> Repair and Diagnosis >> Engine Mechanical >> Blowers, Superchargers & Turbochargers >> Engine Controls And Fuel - 3.6L (LGX) - Repair Instructions >> Repair Instructions >> Fuel Feed Pipe Replacement (At Engine) >> Removal Procedure

Removal Procedure

WARNING:

The noise cancelling foam component MUST be replaced if it has been exposed to engine fluids. Failure to replace the noise cancelling foam component that has been exposed to engine fluids may result in an engine fire resulting in catastrophic engine damage, and possible injury or death.

WARNING:

Fuel/gasoline vapors are highly flammable. A fire could occur if an ignition source is present. Never drain or store gasoline or diesel fuel in an open container, due to the possibility of fire or explosion. Have a dry chemical (Class B) fire extinguisher nearby.

WARNING:

Wear safety glasses in order to avoid eye damage.

  1. Relieve the fuel system pressure. Fuel Pressure Relief 
  2. Engine Rear Noise Shield - Remove - Engine Rear Noise Shield Replacement 
  3. GM4320175

    Wiring Harness Retainer(1) - Unclip[3x]

  4. GM4320343

    Fuel Feed Front Pipe Bracket Bolt(1) - Remove

  5. GM4320359

    Fuel Feed Pipe(1)@Fuel Pump - Disconnect - Metal Collar Quick Connect Fitting Service 

  6. GM4316685

    Fuel Feed Pipe(1) - Disconnect - Metal Collar Quick Connect Fitting Service