|
Preliminary Procedure
- Front Wheelhouse Liner Replacement
- Front Wheel Opening Molding Replacement
- Hood Front Edge Weatherstrip Replacement
|
| 1 |
Front Bumper Fascia Bolt [8x]
Tighten
2.5 N.m (22 lb in) |
| 2 |
Front Bumper Fascia Retainer [2x] |
| 3 |
Front Bumper Fascia Procedure
- Carefully push a small nylon wedge between the fascia and the front fascia guide.Insert a small flat-bladed tool into the fascia slot and depress the snaps one at a time and pull on the fascia at the same time to gradually remove the fascia from the front fascia guide.
- Using a small flat-bladed tool, release the tabs under the headlamp.
- Disconnect the electrical connectors.
- Transfer components as necessary.
- Reconnect the electrical connectors.
- Test and confirm fog lamp operation if required.
|