Transfer Case Two/Four Wheel Drive Actuator Position Sensor Replacement
WARNING: This page is about a different variant/trim than selected.
| Callout | Component Name |
|---|---|
| Preliminary Procedure Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle . |
|
| 1 | Two/Four Wheel Drive Actuator Position Sensor Bolt (Qty: 2)
CAUTION:
Refer to Fastener Caution
. Tighten 6 N.m (53 lb in) |
| 2 | Two/Four Wheel Drive Actuator Position Sensor |
| 3 | Two/Four Wheel Drive Actuator Position Sensor O-Ring Seal Procedure Lightly lubricate the O-ring with clean transfer case fluid. Refer to Adhesives, Fluids, Lubricants and Sealers . |