LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2018 >> Escalade ESV Platinum, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Transfer Case - Mp 3023/3024 (NQH)) >> Repair Instructions - Off Vehicle >> Transfer Case Assemble >> Transfer Case Rear Case Half Installation

Transfer Case Rear Case Half Installation

WARNING: This page is about a different variant/trim than selected.
Fig 1: Transfer Case Rear Case Half
GM1849370Courtesy of GENERAL MOTORS COMPANY
Transfer Case Rear Case Half Installation

Callout Component Name
1 Transfer Case Front Case Half
CAUTION: Apply the proper amount of sealant to the transfer case (front half) sealing surface when assembling the transfer case. Excessive amounts of sealant can plug the oil pump screen, resulting in internal component failure.

Procedure

  1. Ensure both sealing surfaces of the front and rear case halves are free of dirt, oil and cleaning solvent.
  2. Apply a 2 mm (0.078 in) bead of sealant to the front case half. Refer to Adhesives, Fluids, Lubricants and Sealers 
NOTE: Ensure both sealing surfaces of the front and rear case halves are free of dirt, oil and cleaning solvent.
2 Transfer Case Rear Case Half
NOTE:
  • Ensure the transfer case rear output shaft outer retaining ring is in place and aligned prior to mating case halves.
  • Use snap ring pliers to open the transfer case rear output shaft outer retaining ring for the transfer case rear output shaft rear bearing assembly.
  • Insert a rubber coated screwdriver into the speed sensor hole and lift up on the reluctor wheel to engage the retaining ring with the rear bearing assembly.
3 Transfer Case Bracket
4 Transfer Case Bolt (Qty: 17)
CAUTION: Refer to Fastener Caution .
NOTE: Tighten bolts by hand, do not use an air gun.

Tighten 
scientia non olet · About LEMON Manuals