Rear Output Shaft Assembly

WARNING: This page is about a different variant/trim than selected.

Fig 1: Rear Output Shaft Assembly

GM2370846

Courtesy of GENERAL MOTORS COMPANY

Rear Output Shaft Assembly

Callout	Component Name
1	Transfer Case Front Output Shaft Drive Sprocket Spacer - Front
2	Transfer Case Four Wheel Drive Clutch Housing
3	Transfer Case Front Output Shaft Drive Sprocket
4	Transfer Case Four Wheel Drive Clutch Housing Retaining Ring
5	Transfer Case Front Output Shaft Drive Sprocket Spacer - Rear
6	Transfer Case Front Output Shaft Drive Sprocket Retaining Ring NOTE: Ensure the retaining ring is installed into the correct retaining ring groove on the rear output shaft.
7	Transfer Case Oil Pump Assembly
8	Transfer Case Rear Output Shaft Speed Reluctor Wheel
9	Transfer Case Rear Output Shaft Rear Bearing Retaining Ring - Present on Non-Hybrid Applications Only
10	Transfer Case Rear Output Shaft Rear Bearing Assembly Procedure: Use an arbor press or suitable installer to install the bearing to the rear output shaft. Ensure the retaining ring groove in the outer race is positioned toward the rear.
11	Transfer Case Rear Output Shaft Rear Bearing Retaining Ring