Diagnostic Aids

WARNING: This page is about a different variant/trim than selected.

The underhood fuse block supplies B+ on the battery positive voltage circuit and reads the voltage back on the transfer case lock solenoid control circuit.
The system tests the transfer case lock solenoid circuits by checking for unwanted voltage. If the transfer case control module detects a low voltage return when a high voltage is expected, or a high voltage return when a low voltage is expected, the DTC is logged.
The default actions for C0321 may set C0306.
EL-49741 harness is a good source for 9 V.
EL-49742 harness is a good source for B+ and ground.
The transfer case drain plug is a good source for ground.