Conditions for Setting the DTC

WARNING: This page is about a different variant/trim than selected.

The transfer case control module monitors the voltage on 5V reference and 4WD switch signal circuits every 10 ms.

B2725 03

When the low side driver is ON, the transfer case control module measures less than 0.3 volts on the Four Wheel Drive Switch Signal circuit.

B2725 07

When the low side driver is ON, the transfer case control module measures greater than 4.65 volts on the Four Wheel Drive Switch Signal circuit.

B2725 08

When the low side driver is ON, the transfer case control module measures an invalid voltage on the Four Wheel Drive Switch Signal circuit.

P0698

When the ignition is ON, the transfer case control module measures less than 4.75 volts on the Transfer Case Sensor Reference Voltage 3 circuit.

P0699

When the ignition is ON, the transfer case control module measures greater than 5.25 volts on the Transfer Case Sensor Reference Voltage 3 circuit.