LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2018 >> Escalade ESV Platinum, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Transfer Case - Mp 3023/3024 (NQH)) >> Diagnostic Information And Procedures >> DTC B2725, P0698 Or P0699: Transfer Case Range Selection Switch Circuit/5V Reference 3 Circuit >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.
  1. Verify that all range selections of the S77 transfer case shift control switch match the following parameters in the Data Display feature of the scan tool:
    • Transfer Case Commanded Position
    • Transfer Case Range
    • Transfer Case Range Selection Switch State
    • The corresponding Range Indicator light
    • If NOT all of the parameters match the S77 transfer case shift control switch position 

      Refer to Circuit/System Testing below.

    • Go to next step: If ALL of the parameters match the S77 transfer case shift control switch position 
  2. Verify that the sensor reference voltage 3 and transfer case range selection switch voltage fall within the below ranges for all range selections of the S77 transfer case shift control switch.
    • If NOT all voltages match the specified ranges 

      Refer to Circuit/System Testing below.

    • Go to next step: If ALL voltages match the specified ranges 
  3. Verify DTC B2725, P0698 or P0699 is only set as a history DTC.
    • If any of the DTCs are set as current 

      Refer to Circuit/System Testing below.

    • Go to next step: If any of the DTCs are only set as history 
  4. Visually inspect each connector terminal of the K69 transfer case control module X1 connector and the S77 transfer case shift control switch connector for damage or corrosion. Repair as necessary.
    NOTE: After inspection, apply Nyogel lubricant 760G to each connector terminal. Ensure each connector and CPA is correctly seated.
  5. Clear DTC P2725, P0698 or P0699 from history.
  6. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data. The DTC should not set.
    • If any of the DTCs are set 

      Refer to Circuit/System Testing below.

    • Go to next step: If none of the DTCs set 
  7. All OK.
Transfer Case Range Transfer Case Sensor Reference Voltage 3 Transfer Case Range Selection Switch (V) Range Actuator Position Sensor (°)
Range Nominal Range Nominal
2WD 4.7 - 5.3 V 1.8 - 2.2 V 2.0 V 33 - 43° 38°
4WD/AWD Automatic 4.7 - 5.3 V 4.10 - 4.59 V 4.38 V 87 - 204° 146°
4WD High/Locked 4.7 - 5.3 V 2.8 - 3.2 V 3.0 V 110 - 204° 146°
4WD Low 4.7 - 5.3 V 1.3 - 1.7 V 1.5 V -69° to -140° -90°
Neutral 4.7 - 5.3 V 2.3 - 2.7 V 2.5 V Held
1.5 V Released		 -5° to +5° 0°
scientia non olet · About LEMON Manuals