LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2018 >> Escalade ESV Platinum, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 2 (Engine Mechanical - 6.0L (L96)) >> Repair Instructions - On Vehicle >> Upper Intake Manifold Sight Shield Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2018 Chevrolet Suburban 3500 HD. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Intake Manifold Sight Shield Retainer & Bolts
    GM1696801Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  1. Position the intake manifold sight shield on top of the intake manifold, aligning the holes, if required.
  2. Install the intake manifold sight shield retainer bolts, if required.

    Tighten 

    Tighten the bolts to 5 N.m (44 lb in).

    3. Fig 2: Intake Manifold Cover
    GM1696760Courtesy of GENERAL MOTORS COMPANY
  3. Install the intake manifold cover tabs into the slots in the retainer.
  4. Align the intake manifold cover grommets with the studs.
  5. Gently push down on the intake manifold cover over the grommets, seating the intake manifold cover.
  6. Close the hood.
scientia non olet · About LEMON Manuals