LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2018 >> Escalade ESV Platinum, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (Automatic Transmission - 6L80 (MYC) Or 6L90 (MYD) - Diagnostic Information And Procedures) >> Diagnostic Information And Procedures >> DTC P182E Or P1915: Internal Mode Switch >> Circuit/System Description

Circuit/System Description

WARNING: This page is about a different car, the 2018 GMC Yukon XL, 2018 GMC Yukon, 2018 Chevrolet Tahoe, 2018 Chevrolet Suburban 3500 HD, and 2018 Chevrolet Suburban. However, it is still accessible from the selected car via links, so may be relevant.

The manual shift detent lever with shaft position switch assembly or internal mode switch assembly is a sliding contact switch attached to the control valve body within the transmission. The 4 inputs to the Transmission Control Module from the switch indicate which position is selected by the transmission manual shaft. The input voltage at the Transmission Control Module is high when the switch is open and low when the switch is closed to ground. The state of each input is displayed on the scan tool. The input parameters represented are transmission range signal A, Signal B, signal C, and signal P.

The park/neutral position switch is integrated into the transmission internal mode switch. The circuit uses the Transmission Control Module as a pass-through connection only.

The park/neutral signal is sent from the park/neutral switch directly to the engine control module and is used only for engine start enable.

scientia non olet · About LEMON Manuals