LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2018 >> Escalade ESV Platinum, RWD >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical - 5.3L (L83) Or 6.2L (L86) - Repair Instructions - On Vehicle >> Repair Instructions - On Vehicle >> Crankshaft Rear Oil Seal Replacement >> Removal Procedure

Removal Procedure

  1. Remove the automatic transmission flexplate. Refer to Automatic Transmission Flex Plate Replacement .
    2. Fig 1: EN-51096 Crankshaft Rear Seal Remover And GE-23907-1 Slide Hammer
    GM3278199Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    EN-51096  crankshaft rear seal remover has two ends. The end with the small bend will be used to remove the seal.

  2. Install EN-51096  crankshaft rear seal remover onto GE-23907-1  slide hammer.
  3. Slide the small bend of EN-51096  crankshaft rear seal remover between the lip of the rear seal and crankshaft. Ensure that the small bend of EN-51096  crankshaft rear seal remover engages the rear side of the rear seal (1). While rotating EN-51096  crankshaft rear seal remover and GE-23907-1  slide hammer around the seal and use the slide hammer to remove the seal.
  4. Remove and DISCARD the crankshaft rear oil seal (1).
scientia non olet · About LEMON Manuals