LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2018 >> Escalade ESV Platinum, RWD >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical - 5.3L (L83) Or 6.2L (L86) - Repair Instructions - On Vehicle >> Repair Instructions - On Vehicle >> Camshaft Position Actuator Solenoid Valve Replacement

Camshaft Position Actuator Solenoid Valve Replacement

Fig 1: Camshaft Position Actuator Solenoid Valve
GM3285645Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
Preliminary Procedure 
Remove the camshaft position actuator-Magnet. Refer to Camshaft Position Actuator Magnet Replacement .
1 Camshaft Position Actuator Solenoid Valve
CAUTION:

Refer to Component Fastener Tightening Caution .

CAUTION:

The camshaft position actuator solenoid valves must be kept parallel to the engine front cover during removal and installation. The camshaft position actuator solenoid valves can be damaged if they become wedged or stuck during this process.

NOTE:

It is possible to push the camshaft rearward when installing the CMP actuator Valve. Please be careful not to push the camshaft while installing the CMP actuator valve.

NOTE:

The CPA solenoid valve must be Discarded and replaced with a NEW valve.


Tighten 
  1. First pass 65 N.m (48 lb ft).
  2. Final pass 90 degrees.

Special Tools 
J 45059  Angle Meter
For equivalent regional tools, refer to Special Tools .
scientia non olet · About LEMON Manuals