LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2018 >> Escalade ESV Platinum, RWD >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical - 5.3L (L83) Or 6.2L (L86) - Diagnostic Information And Procedures >> Diagnostic Information And Procedures >> DTC P06DA, P06DB, P06DC, P06DD: Engine Oil Pressure Control Solenoid Valve >> Component Testing >> Static Test

Static Test

  1. Ignition/Vehicle - Off
  2. Disconnect the electrical connector:Q44 Engine Oil Pressure Control Solenoid Valve
  3. Test for 10 to 30 Ω between the test points:Control terminal 2/B & Ignition terminal 1/A
    • If not between 10 to 30 Ω 

      Replace the component:Q44 Engine Oil Pressure Control Solenoid Valve

    • Go to next step: If between 10 to 30 Ω 
  4. Test for infinite resistance between the test points:Each terminal of the component & The component's housing
    • If less than infinite resistance 

      Replace the component:Q44 Engine Oil Pressure Control Solenoid Valve

    • Go to next step: If infinite resistance 
  5. All OK.
scientia non olet · About LEMON Manuals