LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2018 >> Escalade ESV Platinum, RWD >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical - 5.3L (L83) Or 6.2L (L86) - Diagnostic Information And Procedures >> Diagnostic Information And Procedures >> DTC P06DA, P06DB, P06DC, P06DD: Engine Oil Pressure Control Solenoid Valve >> Component Testing >> Dynamic Test

Dynamic Test

  1. Ignition/Vehicle - Off
  2. Disconnect the electrical connector:Q44 Engine Oil Pressure Control Solenoid Valve
  3. Connect a 3 A fused jumper wire between the test points:Ignition terminal 1/A & 12 V
  4. Momentarily connect a jumper wire between the test points:Control terminal 2/B & Ground
    CAUTION: Complete the testing as quickly as possible in order to prevent overheating and damaging the component.

    Verify the component turns On and Off when connecting and disconnecting the jumper wire:Q44 Engine Oil Pressure Control Solenoid Valve

    • If the component does not turn On and Off 

      Replace the component:Q44 Engine Oil Pressure Control Solenoid Valve

    • Go to next step: If the component turns On and Off 
  5. All OK.
scientia non olet · About LEMON Manuals