LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2018 >> Escalade ESV Platinum, RWD >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Hydraulic Brake System >> Repair Instructions >> Rear Brake Hose Replacement (JD9 To Caliper) >> Removal Procedure

Removal Procedure

WARNING:

Refer to Brake Dust Warning .

WARNING:

Refer to Brake Fluid Irritant Warning .

CAUTION:

Refer to Brake Fluid Effects on Paint and Electrical Components Caution .

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (6-Lug Wheel)Tire and Wheel Removal and Installation (8-Lug Wheel) .
    3. Fig 1: Brake Pipe Fitting
    GM3629925Courtesy of GENERAL MOTORS COMPANY
  3. Disconnect the brake pipe fitting (1).
  4. Cap the brake pipe fitting to prevent brake fluid loss and contamination.
    5. Fig 2: Brake Hose Bracket Bolt
    GM3629926Courtesy of GENERAL MOTORS COMPANY
  5. Remove the brake hose bracket bolt (1).
    6. Fig 3: Brake Hose Fitting Bolt And Gaskets
    GM3629928Courtesy of GENERAL MOTORS COMPANY
  6. Remove the brake hose fitting bolt (1).
    7. NOTE:

    Do not reuse the brake hose fitting gaskets.

  7. Remove the brake hose fitting gaskets (2) from the brake hose (3).
  8. Discard the brake hose fitting gaskets.
  9. Remove the brake hose.
scientia non olet · About LEMON Manuals