LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2018 >> Escalade ESV Platinum, RWD >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Hydraulic Brake System >> Repair Instructions >> Rear Brake Hose Replacement (J95 To Caliper) >> Installation Procedure

Installation Procedure

  1. Install the brake hose to the vehicle.
    2. Fig 1: Brake Hose Fitting And Gaskets
    GM4144354Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Install NEW brake hose fitting gaskets.

  2. Install Brake Hose Fitting Gasket (1) @ Brake Hose Fitting (2)
    3. Fig 2: Brake Hose Fitting Bolt
    GM4144352Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  3. Install Brake Hose Fitting Bolt (1) and tighten 40 N.m (30 lb ft)
    4. Fig 3: Brake Hose Bracket Bolt
    GM4144350Courtesy of GENERAL MOTORS COMPANY
  4. Install Brake Hose Bracket Bolt (1) and tighten 22 N.m (16 lb ft)
    5. Fig 4: Brake Pipe Fitting
    GM4144346Courtesy of GENERAL MOTORS COMPANY
  5. Install Brake Pipe Fitting (2) and tighten 25 N.m (18 lb ft)
  6. Bleed the brake system. Hydraulic Brake System Bleeding (Manual) Hydraulic Brake System Bleeding (Pressure) 
  7. Install the tire and wheel assembly. Tire and Wheel Removal and Installation (6-Lug Wheel)Tire and Wheel Removal and Installation (8-Lug Wheel)
scientia non olet · About LEMON Manuals