LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2018 >> Escalade ESV Platinum, RWD >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Hydraulic Brake System >> Repair Instructions >> Power Brake Booster Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Power Brake Booster Nuts
    GM2407267Courtesy of GENERAL MOTORS COMPANY
  1. Install the power brake booster.
    2. CAUTION:

    Refer to Fastener Caution .

    NOTE:

    Tighten the upper right hand nut first.

  2. Install the 4 power brake booster nuts (1) and tighten to 33 N.m (24 lb ft).
    3. Fig 2: Brake Booster Pushrod Retainer Clip
    GM2407257Courtesy of GENERAL MOTORS COMPANY
  3. Install the power brake booster pushrod to the brake pedal pin.
  4. Install the brake booster pushrod retainer clip (1).
    5. Fig 3: Brake Booster Pushrod Retainer Clip Bolt
    GM2407253Courtesy of GENERAL MOTORS COMPANY
  5. Install the power brake booster pushrod retainer clip bolt (1) and tighten to 10 N.m (89 lb in).
    6. Fig 4: Power Brake Booster Fluid Outlet Pipe Fitting
    GM2407273Courtesy of GENERAL MOTORS COMPANY
  6. Install the power brake booster hose outlet pipe fitting (1) and tighten to 33 N.m (24 lb ft).
    7. Fig 5: Power Brake Booster Fluid Inlet Pipe Fitting
    GM2407271Courtesy of GENERAL MOTORS COMPANY
  7. Install the power brake booster hose inlet pipe fitting (1) and tighten to 33 N.m (24 lb ft).
    8. Fig 6: Power Brake Booster Fluid Return Hose
    GM2407269Courtesy of GENERAL MOTORS COMPANY
  8. Install the power brake booster fluid return hose (1) and secure the clamp.
  9. Install the brake master cylinder. Refer to Brake Master Cylinder Replacement .
  10. Bleed the power steering system. Refer to Power Steering System Bleeding .
  11. Calibrate the brake pedal position sensor. Refer to Brake Pedal Position Sensor Calibration .
scientia non olet · About LEMON Manuals