LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2018 >> Escalade ESV Platinum, RWD >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Hydraulic Brake System >> Repair Instructions >> Front Brake Hose Replacement (JD9) >> Removal Procedure

Removal Procedure

WARNING:

Refer to Brake Dust Warning .

WARNING:

Refer to Brake Fluid Irritant Warning .

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (6-Lug Wheel)Tire and Wheel Removal and Installation (8-Lug Wheel) .
    3. Fig 1: Brake Pipe Fitting
    GM3269630Courtesy of GENERAL MOTORS COMPANY
  3. Disconnect the brake pipe fitting (1).
  4. Cap the brake pipe fitting to prevent brake fluid loss and contamination.
    5. Fig 2: Wheel Speed Sensor Harness Retainers
    GM3269632Courtesy of GENERAL MOTORS COMPANY
  5. Release the wheel speed sensor harness retainers (1) from the brake hose brackets.
    6. Fig 3: Brake Hose Bracket Bolt
    GM3269633Courtesy of GENERAL MOTORS COMPANY
  6. Remove the brake hose bracket bolt (1) from the frame.
    7. Fig 4: Brake Hose Bracket Bolt
    GM3269659Courtesy of GENERAL MOTORS COMPANY
  7. Remove the brake hose bracket bolt (1) from the upper control arm.
    8. Fig 5: Brake Hose Fitting Bolt
    GM3258629Courtesy of GENERAL MOTORS COMPANY
  8. Remove the brake hose fitting bolt (1).
    9. NOTE:

    Do not reuse the brake hose fitting gaskets.

  9. Remove and discard the brake hose fitting gaskets (2) from the brake hose (3).
  10. Remove the brake hose.
scientia non olet · About LEMON Manuals