Removal Procedure
WARNING:
Refer to Brake Fluid Irritant Warning .
CAUTION:
Refer to Brake Fluid Effects on Paint and Electrical Components Caution .
- With the engine OFF, apply and release the brake pedal several times until the pedal becomes firm to deplete the brake booster reserve assist.
- Remove the driver side front fender rear upper brace. Refer to Front Fender Rear Upper Brace Replacement .
- Disconnect the brake fluid level indicator switch electrical connector.
- Disconnect the master cylinder secondary brake pipe fitting (1).
- Cap the brake pipe fitting and plug the master cylinder outlet port to prevent brake fluid loss and contamination.
- Disconnect the master cylinder primary brake pipe fitting (2).
- Cap the brake pipe fitting and plug the master cylinder outlet port to prevent brake fluid loss and contamination.
- Remove the master cylinder nuts (1).
- Remove the master cylinder (1) from the power vacuum brake booster.
- Inspect the O-ring seal (2) for damage and replace, if necessary.