Video Auxiliary Display Replacement (Third Row)

Fig 1: Video Auxiliary Display (Third Row)

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedure Remove the video auxiliary display cover. Refer to Video Auxiliary Display Cover Replacement .
1	Video Display Assembly Fastener (Qty: 4) CAUTION: Refer to Fastener Caution . Tighten 2 N.m (18 lb in) NOTE: Make sure that all 4 washers on the 4 mounting screws are accounted for. If any washers are off the screw and loose, discard to prevent a rattle. The washers were required only for assembly plant installation, and can be used if still on the screw or they can be discarded.
2	Video Auxiliary Display Procedure Release the connector position assurance (CPA) retainer, if equipped. Disconnect the electrical connector. NOTE: The CPA is located on the top of the connector, facing the roof.

Callout

Component Name

Preliminary Procedure
Remove the video auxiliary display cover. Refer to Video Auxiliary Display Cover Replacement .

Video Display Assembly Fastener (Qty: 4)

CAUTION:

Refer to Fastener Caution .

Tighten
2 N.m (18 lb in)

NOTE:

Make sure that all 4 washers on the 4 mounting screws are accounted for. If any washers are off the screw and loose, discard to prevent a rattle. The washers were required only for assembly plant installation, and can be used if still on the screw or they can be discarded.

Video Auxiliary Display

Procedure

Release the connector position assurance (CPA) retainer, if equipped.
Disconnect the electrical connector.

NOTE:

The CPA is located on the top of the connector, facing the roof.