LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2018 >> Escalade ESV Platinum, RWD >> Repair and Diagnosis >> Accessories & Equipment >> Exterior Lights >> Lighting System - DTC C0277 To DTC C0297 And Diagnostic Information And Procedures >> Diagnostic Information And Procedures >> Dome Lamps Malfunction >> Circuit/System Verification

Circuit/System Verification

  1. Ignition ON.
  2. Verify the exterior courtesy lamps listed below, if equipped, turn ON and OFF while commanding the Outside Rear View Mirror Courtesy Lamp ON and OFF with a scan tool.
    • A9A Outside Rearview Mirror - Driver (with DL3/DR4)
    • A9B Outside Rearview Mirror - Passenger (with DL3/DR4)
    • A24D Door Handle Assembly - Driver Exterior (with Z75)
    • A24P Door Handle Assembly - Passenger Exterior (with Z75)
    • A24LR Door Handle Assembly - Left Rear Exterior (with Z75)
    • A24RR Door Handle Assembly - Right Rear Exterior (with Z75)
    • E8ZL Running Board Step Courtesy Lamp - Left (with BRS)
    • E8ZR Running Board Step Courtesy Lamp - Right (with BRS)
    • Go to next step: If the exterior courtesy lamps turn ON and OFF 
  3. Verify the center console compartment lamp, both sunshade lamps and ALL reading lamps operate ON/OFF when activated.
    • If the center console compartment lamp, both sunshade lamps and ALL reading lamps do not activate 

      Refer to Courtesy Lamps Malfunction .

    • Go to next step: If the center console compartment lamp, both sunshade lamps, and ALL reading lamps activate 
  4. Verify the scan tool Door Ajar Switch parameter changes between Active and Inactive while opening and closing each vehicle door.
    • Go to next step: If the parameter changes 
  5. Verify the scan tool Interior/Courtesy Lighting Master Switch parameter changes between Door, On and Cancel while placing the dome lamp switch in the Door, On and Cancel positions.
    • Go to next step: If the parameter changes 
  6. Verify the dome lamps and door sill plate lamps if equipped, turn ON and OFF while commanding the Courtesy Lamps ON and OFF with a scan tool.
    • Go to next step: If the dome lamps turn ON and OFF 
  7. All OK.