LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2018 >> Escalade ESV Platinum, RWD >> Repair and Diagnosis >> Accessories & Equipment >> Exterior Lights >> Lighting System - DTC B0655 To DTC B3951 >> Diagnostic Information And Procedures >> DTC B2530: Front Fog Lamps Control Circuit >> Circuit/System Testing

Circuit/System Testing

  1. Ignition OFF, disconnect the X5 harness connector at the K9 Body Control Module.
  2. Connect a 3 A fused jumper between the control circuit terminal 10 and Ground, ignition ON.
  3. Verify a test lamp illuminates between the F94UA Fuse test point and ground.
    • If the test lamp does not illuminate 
    1. Ignition OFF, disconnect the X3 harness connector at the X50A Fuse Block - Underhood.
    2. Test for less than 1 V between the control circuit terminal and ground.
      • If 1 V or greater, repair the short to voltage on the circuit.
      • If less than 1 V.
    3. Test for less than 2 Ω in the control circuit end to end.
      • If 2 Ω or greater, repair the open/high resistance in the circuit.
      • If less than 2 Ω, replace the X50A Fuse Block - Underhood.
    • Go to next step: If the test lamp illuminates 
  4. Ignition OFF, remove the fused jumper wire
  5. Ignition ON, verify the test lamp does not illuminate between the F94UA Fuse test point and ground
    • If the test lamp illuminates 
    1. Ignition OFF, disconnect the X3 harness connector at the X50A Fuse Block - Underhood.
    2. Test for infinite resistance between the control circuit and ground.
      • If less than infinite resistance, repair the short to ground on the circuit.
      • If infinite resistance, replace the X50A Fuse Block - Underhood
    • Go to next step: If the test lamp does not illuminate 
  6. Replace the K9 Body Control Module
scientia non olet · About LEMON Manuals