LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2018 >> Escalade Base, RWD >> Repair and Diagnosis >> Engine Mechanical >> Blowers, Superchargers & Turbochargers >> Engine Controls And Fuel - 5.3L (L83) Or 6.2L (L86) - Repair Instructions >> Repair Instructions >> Fuel Feed And Evaporative Emission Hose Replacement >> Installation Procedure

Installation Procedure

    Fig 1: EVAP hose
    GM3637262Courtesy of GENERAL MOTORS COMPANY
  1. Install the fuel feed and EVAP hose (3) to the vehicle and retainers.
  2. Connect the fuel pressure sensor electrical connector.
  3. Connect the fuel hose (2) to the fuel pipe. Refer to Plastic Collar Quick Connect Fitting Service .
  4. Connect the EVAP hose (1) to the EVAP pipe. Refer to Plastic Collar Quick Connect Fitting Service .
    5. Fig 2: Fuel Feed And EVAP Hose Nut
    GM3273722Courtesy of GENERAL MOTORS COMPANY
  5. Install the fuel feed and EVAP hose (4) to the retainers.
  6. Connect the EVAP hose (3) to the EVAP canister purge tube. Refer to Plastic Collar Quick Connect Fitting Service .
  7. Connect the fuel hose (2) to the fuel rail. Refer to Metal Collar Quick Connect Fitting Service .
    8. CAUTION:

    Refer to Fastener Caution .

  8. Install the fuel feed and EVAP hose nut (1) and torque to 25 N.m (18 lb ft).
  9. Raise the transmission back to it original position. Transmission Replacement , for the 6L80 or Transmission Replacement for the 8L90.
scientia non olet · About LEMON Manuals