Rear Side Door Trim Replacement (Chevrolet, GMC)

Fig 1: Rear Side Door Trim (Chevrolet, GMC)

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
1	Rear Side Door Inside Handle Bolt Finish Cap Procedure Use a suitable tool, place the tool between the notch located at the rear of the door handle cap and the door handle. Turn the suitable tool clockwise releasing the door handle cap, exposing the handle fastener.
2	Rear Side Door Inside Handle Fastener CAUTION: Refer to Fastener Caution . Tighten 1.4 N.m (12 lb in)
3	Rear Side Door Armrest Pull Cup Bolt Cap Procedure Using a suitable tool, place the tool between the notch located at the rear of the door armrest cap and the rear side door pull cup. Cap must be lifted up then back to disengage integral tabs and front hook feature.
4	Rear Side Door Armrest Pull Cup Fastener (Qty: 2) Tighten 2.5 N.m (22 lb in)
5	Rear Side Door Trim Panel Fastener Tighten 2.5 N.m (22 lb in)
6	Rear Side Door Trim Panel Assembly Procedure Using a plastic trim stick, separate the trim panel from the sheet metal at the top right corner until you are able to place your fingers in between. From the top right side, detach door by pulling clockwise around the border of the door trim without pulling up on the top area. Cover the window garnish molding before moving to the next step to prevent damage. Push the door up in order to disengage metal retention clips on top of door. Disconnect the door lock retainer cable from the door trim panel and the inside handle. Unclip the harness retainers from the door trim. Disconnect the electrical connectors. Place the door trim panel on a clean flat surface. Remove the rear side door window inner sealing strip and metal retainer clips from door trim panel, if necessary. Refer to Rear Side Door Window Inner Sealing Strip Replacement (Short Wheelbase)Rear Side Door Window Inner Sealing Strip Replacement (Long Wheelbase) . When installing the door trim panel, reinstall metal clips and rear side door window inner sealing strip prior to installing door trim panel.