LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2018 >> Escalade Base, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 8 (Engine Controls And Fuel - 6.0L (L96) - Repair Instructions) >> Repair Instructions >> Fuel Tank Pressure Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2018 Chevrolet Suburban 3500 HD. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Fuel Tank Pressure Sensor (2500)
    GM1705812Courtesy of GENERAL MOTORS COMPANY
  1. Lubricate the seal on the fuel pressure sensor.
  2. Press the fuel pressure sensor into the line.
  3. Install the intermediate fuel and EVAP lines. Refer to Evaporative Emission System Hose/Pipe Replacement (Front Tank) Evaporative Emission System Hose/Pipe Replacement (Intermediate) .
scientia non olet · About LEMON Manuals