LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2018 >> Escalade Base, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 8 (Engine Controls And Fuel - 6.0L (L96) - Repair Instructions) >> Repair Instructions >> Evaporative Emission Line Replacement - Canister To Tank (Rear Tank) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2018 Chevrolet Suburban 3500 HD. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:

Clean the evaporative emission (EVAP) line connections and surrounding areas prior to disconnecting the fittings in order to avoid possible EVAP system contamination.

    Fig 1: EVAP Line Clips
    GM1705753Courtesy of GENERAL MOTORS COMPANY
  1. Remove the rear fuel tank. Refer to Fuel Tank Replacement (Rear Tank) .
  2. Remove the EVAP line from the clip (1) on the fuel tank.
  3. Open the EVAP line clip (2) and remove the EVAP line from the clip.
  4. Remove the EVAP lines from the clip (3).
  5. Disconnect the EVAP line quick connect fittings from the fuel tank module. Refer to Plastic Collar Quick Connect Fitting Service .
    6. Fig 2: Fuel Tank EVAP Lines
    GM1705754Courtesy of GENERAL MOTORS COMPANY
  6. Remove the EVAP lines from the fuel tank.
scientia non olet · About LEMON Manuals