LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2018 >> Escalade Base, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 8 (Engine Controls And Fuel - 6.0L (L96) - Repair Instructions) >> Repair Instructions >> Evaporative Emission Canister Vent Solenoid Valve Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2018 Chevrolet Suburban 3500 HD. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:

Clean all evaporative emission (EVAP) line connections and surrounding areas prior to disconnecting, in order to avoid possible EVAP system contamination.

    Fig 1: EVAP Canister Vent Solenoid Electrical Connector (2500 Series)
    GM1224403Courtesy of GENERAL MOTORS COMPANY
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Disconnect the chassis wiring harness electrical connector (1) from the EVAP canister vent solenoid.
    3. Fig 2: EVAP Canister Vent Solenoid Retainer
    GM1706538Courtesy of GENERAL MOTORS COMPANY
  3. Disconnect the EVAP canister vent solenoid line quick connect fitting from the vent solenoid. Refer to Plastic Collar Quick Connect Fitting Service .
  4. Disengage the retainer (1) securing the EVAP canister vent solenoid to the bracket.
  5. Remove the EVAP canister vent solenoid.
scientia non olet · About LEMON Manuals