LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2018 >> Escalade Base, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 8 (Engine Controls And Fuel - 6.0L (L96) - Repair Instructions) >> Repair Instructions >> Engine Control Module Bracket Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2018 Chevrolet Suburban 3500 HD. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Battery Tray Bolts And Engine Control Module Bracket
    GM5035215Courtesy of GENERAL MOTORS COMPANY
  1. Install Engine Control Module Bracket (2)
    2. CAUTION:

    Refer to Fastener Caution

  2. Install and tighten Battery Tray Bolts (1) (Qty: 2) to 9 N.m (80 lb in)
    3. Fig 2: Engine Control Module Bracket Bolt
    GM5035211Courtesy of GENERAL MOTORS COMPANY
  3. Install and tighten Engine Control Module Bracket Bolt (1) to 9 N.m (80 lb in)
  4. Install the left front wheelhouse liner. Refer to Front Wheelhouse Liner Replacement - Left Side (Chevrolet)
  5. Install Engine Control Module. Refer to Engine Control Module Replacement 
  6. Install Auxiliary Battery. Refer to Auxiliary Battery Replacement (9C1)
scientia non olet · About LEMON Manuals