LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2018 >> Escalade Base, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 8 (Engine Controls And Fuel - 6.0L (L96) - Repair Instructions) >> Repair Instructions >> Crankshaft Position Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2018 Chevrolet Suburban 3500 HD. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

Perform the Crankshaft Position Variation Learn  whenever the crankshaft position sensor is removed or replaced.

    Fig 1: Engine Wiring Harness Electrical Connectors And Components
    GM1698087Courtesy of GENERAL MOTORS COMPANY
  1. Remove the starter. Refer to Starter Replacement (L96) .
  2. Working through the wheel well opening, disconnect the engine wiring harness electrical connector (1) from the crankshaft position (CKP) sensor.
    3. Fig 2: CKP Sensor And Bolt
    GM1239292Courtesy of GENERAL MOTORS COMPANY
  3. Clean the area around the CKP sensor before removal in order to avoid debris from entering the engine.
  4. Remove the CKP sensor bolt.
  5. Remove the CKP sensor.
scientia non olet · About LEMON Manuals