LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2018 >> Escalade Base, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 5 (Engine Controls And Fuel - 6.0L (L96) - DTC P0010 To DTC P0341) >> Diagnostic Information And Procedures >> DTC P00F4, P00F5, P00F6: Intake Air Humidity Sensor Circuit >> Component Testing >> Multifunction Intake Air Sensor

Multifunction Intake Air Sensor

WARNING: This page is about a different car, the 2018 Chevrolet Suburban 3500 HD. However, it is still accessible from the selected car via links, so may be relevant.
  1. Test the Intake Air Humidity Sensor by varying the air humidity in the intake duct near the sensor, while observing the scan tool Intake Air Humidity Sensor parameter. The parameter should change and be within 5 - 95%.
    • If not within 5 - 95%, or the parameter does not change. 

      Replace the K20 Engine Control Module.

    • Go to next step: If within 5 - 95% and the parameter does change 
  2. All OK.
scientia non olet · About LEMON Manuals