LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2018 >> Escalade Base, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (Automatic Transmission - 6L80 (MYC) Or 6L90 (MYD) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Input And Output Speed Sensor Replacement

Input And Output Speed Sensor Replacement

WARNING: This page is about a different car, the 2018 GMC Yukon XL, 2018 GMC Yukon, 2018 Chevrolet Tahoe, 2018 Chevrolet Suburban 3500 HD, and 2018 Chevrolet Suburban. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Input And Output Speed Sensor
GM1657185Courtesy of GENERAL MOTORS COMPANY
Callout Component Name

Preliminary Procedures

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the transmission fluid pan and filter. Refer to Automatic Transmission Fluid, Fluid Pan and/or Filter Replacement .
  3. Remove the upper and lower valve body assembly. Refer to Control Valve Lower Body and Upper Body Replacement .
1 Speed Sensor Electrical Connector
2 Input and Output Speed Sensor Assembly Bolt (Qty: 2)
CAUTION:

Refer to Fastener Caution .


Tighten 
12 N.m (106 lb in)
3 Input and Output Speed Sensor Assembly Clips (Qty: 2)
Procedure 
Inspect the wiring harness clips for damage. Replace if necessary.
4 Input and Output Speed Sensor Assembly
scientia non olet · About LEMON Manuals