Installation Procedure
- Install a NEW filter plate assembly (1).
- Align the control solenoid valve assembly (1) to the control valve lower body assembly.
- Install the 2 bolts (2), through the "heat sink" side of the control solenoid valve assembly (1). Hand tighten only.
- Install the 4 bolts (1) and 5 bolts (2) securing the control solenoid valve assembly to the control valve lower body assembly. Hand tighten only.
- Install the manual shift shaft position switch assembly (1). Align the switch activator slide with the manual valve link. Secure with 1 bolt (3). Hand tighten only.
- Connect and lock the manual shift shaft position switch electrical connector (5) to the control solenoid valve assembly and attach the wiring harness clip (4).
- Tighten all bolts in the sequence shown. The 2 "heat sink" bolts (17, 18) must be tightened last.
Tighten bolts to 8 N.m (71 lb in).
- Inspect the contact area between the "heat sink" area of the control solenoid valve assembly (1) and the valve body. There should be no visible gap. If a gap exists, loosen all 18 bolts and retighten in the sequence shown.
- Inspect the 2 input and output speed sensor wiring harness clips (1) for damage. Replace if damaged.
- Connect the speed sensor electrical connector (2) to the control solenoid valve assembly.
- Install the upper and lower control valve body assembly. Refer to Control Valve Lower Body and Upper Body Replacement .
- Install the electrical connector passage sleeve. Refer to Automatic Transmission Electrical Connector Passage Sleeve Replacement .
- Install the transmission oil pan and filter. Refer to Automatic Transmission Fluid, Fluid Pan and/or Filter Replacement .
- If a NEW TCM has been installed into the vehicle, the NEW module needs to be reprogrammed. Refer to Service Programming System (SPS) .
- Transmission internal service/overhaul
- Valve body repair or replacement
- Control solenoid valve assembly replacement
- TCM software/calibration update
- Any service in response to a shift quality concern
- Perform the Reset Transmission Adapts. Refer to Reset Transmission Adapts .
Inspect the 4 filter plate retaining tabs on the control solenoid valve assembly. A broken or missing tab may not adequately secure the filter plate to the control solenoid valve assembly.
Note the locator pin on the control valve lower body assembly.
The wiring harness clip (4) on the manual shift shaft position switch does not need to be replaced if damaged or missing. The clip functions only as a manufacturing assembly aid to keep the harness clear during an automated bolt installation process. If the clip is damaged, simply remove and discard.
Bolt torque sequencing is critical to the proper function of the control solenoid valve assembly. Failure to follow the required sequencing may result in transmission malfunction.
Refer to Fastener Caution .
When following the tightening sequence, skip over bolts 10, 11, 12, 13 and 15. These bolts are not removed for this procedure.
The Service Fast Learn Adapts procedure must be performed when one of the following repairs have been made to the vehicle. Failure to perform the procedure after one of the following repairs may result in poor transmission performance, as well as transmission DTCs being set: