Transmission Case Front Cover And Drive Link Installation

WARNING: This page is about a different car, the 2018 Chevrolet Suburban 3500 HD. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Transmission Case Front Cover And Drive Link (With Tightening Sequence)

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
1	Automatic Transmission Front Support Cover Gasket NOTE: Install a NEW gasket.
2	Drive Sprocket Thrust Washer - Rear
3	Drive Sprocket
4	Drive Link
5	Drive Sprocket Thrust Washer - Front
6	Automatic Transmission Case Front Cover Seal NOTE: Install a NEW seal.
7	Automatic Transmission Case Front Cover NOTE: Ensure the drive link assembly is not pinched by the front cover and moves freely on the drive sprocket.
8	Automatic Transmission Case Front Cover Bolt M6 x 30 (Qty: 11) CAUTION: Refer to Fastener Caution . Procedure Tighten the bolts in the sequence shown. NOTE: Use NEW bolts. Tighten 9.5 N.m (84 lb in)