Stator Shaft Support Installation
WARNING: This page is about a different car, the 2018 Chevrolet Suburban 3500 HD. However, it is still accessible from the selected car via links, so may be relevant.
| Callout | Component Name |
|---|---|
| 1 | Stator Shaft Support Procedure Align the bolt hole indicated by the arrow with the arrow that is cast into the case and push down to seat. |
| 2 | Stator Shaft Support Bolt M8 x 33 mm (Qty: 9)
CAUTION:
Refer to Fastener Caution . Procedure Tighten the bolts in the sequence shown. Tighten in sequence 35 N.m (26 lb ft) |
| 3 | Turbine Shaft Seal
NOTE:
Install a NEW seal. |