Stator Shaft Support Assemble

WARNING: This page is about a different car, the 2018 Chevrolet Suburban 3500 HD. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Stator Shaft Support

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
1	Torque Converter Fluid Seal CAUTION: Do not use old seal rings. Install NEW seal rings. Reusing old seal rings may cause internal transmission leaks and transmission damage. CAUTION: Size the fluid seal rings for at least 5 minutes after installation to obtain proper seal ring size. Failure to do so may cause internal transmission leaks and transmission damage. Procedure NOTE: Use the large taper side of DT-50912-1 seal sizer for initial seal sizing, then flip the tool over for final sizing. Install a NEW seal. Do NOT reuse the old seal. Special Tool DT-50912 Seal Installer Equivalent regional tools: Special Tools
2	1-3-5-6-7 Clutch Fluid Seal Ring (Qty: 2) Procedure NOTE: Ensure fluid seal ring is installed properly as shown. Install NEW seals. Do NOT reuse old seals.

Callout

Component Name

Torque Converter Fluid Seal

CAUTION:

Do not use old seal rings. Install NEW seal rings. Reusing old seal rings may cause internal transmission leaks and transmission damage.

CAUTION:

Size the fluid seal rings for at least 5 minutes after installation to obtain proper seal ring size. Failure to do so may cause internal transmission leaks and transmission damage.

Procedure

NOTE:

Use the large taper side of DT-50912-1 seal sizer for initial seal sizing, then flip the tool over for final sizing.

Install a NEW seal. Do NOT reuse the old seal.
Special Tool
DT-50912 Seal Installer
Equivalent regional tools: Special Tools

1-3-5-6-7 Clutch Fluid Seal Ring (Qty: 2)
Procedure

NOTE:

Ensure fluid seal ring is installed properly as shown.

Install NEW seals. Do NOT reuse old seals.