Automatic Transmission Fluid Pump Assembly Installation
WARNING: This page is about a different car, the 2018 Chevrolet Suburban 3500 HD. However, it is still accessible from the selected car via links, so may be relevant.
Automatic Transmission Fluid Pump Assembly Installation
| Callout | Component Name |
|---|---|
| 1 | Automatic Transmission Fluid Pump Locating Pin (Qty: 2) |
| 2 | Automatic Transmission Fluid Pump Passage Sleeve |
| 3 | Automatic Transmission Fluid Pump Drive Shaft Bushing |
| 4 | Automatic Transmission Fluid Pump Gasket
NOTE:
Install a NEW gasket, it is not reusable. |
| 5 | Automatic Transmission Fluid Pump Seal Procedure Install the seal onto the pump as shown. "Side Up", indicated by the arrow, should face away from the pump assembly.
NOTE:
Install a NEW seal, it is not reusable. |
| 6 | Automatic Transmission Fluid Pump |
| 7 | Automatic Transmission Fluid Pump Bolt M6 x 28 (Qty: 5)
CAUTION:
Refer to Fastener Caution . Tighten in sequence 9 N.m (80 lb in) |