Torque Converter Housing With Fluid Pump Disassemble
WARNING: This page is about a different car, the 2018 GMC Yukon XL, 2018 GMC Yukon, 2018 Chevrolet Tahoe, 2018 Chevrolet Suburban 3500 HD, and 2018 Chevrolet Suburban. However, it is still accessible from the selected car via links, so may be relevant.
| Callout | Component Name |
|---|---|
|
CAUTION:
Do not loosen or remove the 6 bolts securing the clutch support to the pump cover assembly. These bolts have been installed and torqued only after specific clutch support rotational requirements have been met. If the clutch support is not installed properly, damage to the transmission will occur.
|
|
| 1 | 1-2-3-4 and 3-5-Reverse Clutch Housing Thrust Washer |
| 2 | Automatic Transmission Fluid Pump Cover Bolt (Qty: 13) |
| 3 | Automatic Transmission Fluid Pump Cover |
| 4 | Automatic Transmission Fluid Pump Vane Ring |
| 5 | Automatic Transmission Fluid Pump Rotor |
| 6 | Automatic Transmission Fluid Pump Vane (Qty: 13) |
| 7 | Automatic Transmission Fluid Pump Rotor Guide |
| 8 | Automatic Transmission Fluid Pump Vane Ring |
| 9 | Automatic Transmission Fluid Pump Slide Outer Spring |
| 10 | Automatic Transmission Fluid Pump Slide |
| 11 | Automatic Transmission Fluid Pump Slide Seal |
| 12 | Automatic Transmission Fluid Pump Slide Fluid Seal Ring |
| 13 | Automatic Transmission Fluid Pump Slide Seal |
| 14 | Automatic Transmission Fluid Pump Slide Seal Support |
| 15 | Automatic Transmission Fluid Pump Slide Pivot Pin |