Automatic Transmission Electrical Connector Passage Sleeve Installation

WARNING: This page is about a different car, the 2018 GMC Yukon XL, 2018 GMC Yukon, 2018 Chevrolet Tahoe, 2018 Chevrolet Suburban 3500 HD, and 2018 Chevrolet Suburban. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Automatic Transmission Electrical Connector Passage Sleeve

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
1	Automatic Transmission Electrical Connector Passage Sleeve Seal Procedure Install a NEW seal. Do NOT reuse the old seal.
2	Automatic Transmission Wiring Connector Seal (Qty: 2) Procedure Install a NEW seal. Do NOT reuse the old seal.
3	Automatic Transmission Electrical Connector Passage Sleeve CAUTION: Orientate the alignment tab inside the passage sleeve with the slot in the electrical connector of the control solenoid valve assembly. Push the sleeve straight into the case bore and connector. Do NOT rotate the sleeve at any time. Ensure the sleeve is fully seated into the case. When the sleeve is properly installed, the distance from the case surface to the end of the sleeve should be 14-16 mm. Even though the correct electrical connections may still be maintained, failure to ensure proper installation of the sleeve may result in a fluid leak around the sleeve lip seal and into the sleeve cavity. Procedure Align the tab inside the passage sleeve with the slot in the electrical connector. Using DT-47715 and EN-42183, install the sleeve to 14-16 mm (0.5512-0.6299 in) (a). Push down on the connector position assurance (CPA) tab to ensure proper installation. Special Tools DT-47715 Electrical Connector Passage Sleeve Remover/Installer EN-42183 Driver Handle Equivalent regional tools: Special Tools

Callout

Component Name

Automatic Transmission Electrical Connector Passage Sleeve Seal
Procedure
Install a NEW seal. Do NOT reuse the old seal.

Automatic Transmission Wiring Connector Seal (Qty: 2)
Procedure
Install a NEW seal. Do NOT reuse the old seal.

Automatic Transmission Electrical Connector Passage Sleeve

CAUTION: Orientate the alignment tab inside the passage sleeve with the slot in the electrical connector of the control solenoid valve assembly. Push the sleeve straight into the case bore and connector. Do NOT rotate the sleeve at any time. Ensure the sleeve is fully seated into the case. When the sleeve is properly installed, the distance from the case surface to the end of the sleeve should be 14-16 mm. Even though the correct electrical connections may still be maintained, failure to ensure proper installation of the sleeve may result in a fluid leak around the sleeve lip seal and into the sleeve cavity.

Procedure

Align the tab inside the passage sleeve with the slot in the electrical connector.
Using DT-47715 and EN-42183, install the sleeve to 14-16 mm (0.5512-0.6299 in) (a).
Push down on the connector position assurance (CPA) tab to ensure proper installation.

Special Tools

DT-47715 Electrical Connector Passage Sleeve Remover/Installer
EN-42183 Driver Handle

Equivalent regional tools: Special Tools