2 - 6 Clutch Plates Installation

WARNING: This page is about a different car, the 2018 GMC Yukon XL, 2018 GMC Yukon, 2018 Chevrolet Tahoe, 2018 Chevrolet Suburban 3500 HD, and 2018 Chevrolet Suburban. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: 2-6 Clutch Plates

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
1	2 - 6 Clutch (Waved) Plate
2	2 - 6 Clutch Plates (Qty: 6) NOTE: Alternate between steel and fiber clutch plates.
3	2 - 6 Clutch Plate Assembly (Qty: 6) NOTE: Alternate between steel and fiber clutch plates.
4	2 - 6 Clutch Backing Plate
5	2 - 6 Clutch Backing Plate Retaining Ring CAUTION: When installed, the open end of the snap ring must orient away from the slotted and scalloped areas of the center support assembly. Ideal orientation location should be at the 3 o'clock or 9 o'clock position of the center support, when facing the pan side of the case. Orienting the snap ring opening with either the scalloped or slotted areas of the center support may cause transmission damage. Procedure Be sure to install the retaining ring gap at the 9 o'clock or 3 o'clock position, as indicated by the arrows.
6	2 - 6 Clutch Apply Passage NOTE: Apply air to verify proper installation of all 2 - 6 clutch components.