3 - 5 Reverse Clutch Housing Inspection Assembled

WARNING: This page is about a different car, the 2018 GMC Yukon XL, 2018 GMC Yukon, 2018 Chevrolet Tahoe, 2018 Chevrolet Suburban 3500 HD, and 2018 Chevrolet Suburban. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Inspecting 3-5 Reverse Clutch Housing

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
1	1-2-3-4 and 3-5 Reverse Clutch Housing Assembly Procedure Apply soap compound to weld area of housing. Hold thumb over the air bleed passage. For fully assembled 1-2-3-4 and 3-5 reverse clutch housing spray compressed air into the 3-5R clutch feed hole and inspect weld area for bubbles. If bubbles are detected a new housing is required.

Callout

Component Name

1-2-3-4 and 3-5 Reverse Clutch Housing Assembly

Procedure

Apply soap compound to weld area of housing.
Hold thumb over the air bleed passage.
For fully assembled 1-2-3-4 and 3-5 reverse clutch housing spray compressed air into the 3-5R clutch feed hole and inspect weld area for bubbles.
If bubbles are detected a new housing is required.