Circuit/System Verification
WARNING: This page is about a different car, the 2018 Chevrolet Suburban 3500 HD. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition - On/Vehicle - In Service Mode
- Verify the scan tool parameter: 9V Reference 2 Circuit Status = OK or Not Run
- If not the specified state
Refer to: Circuit/System Testing
- Go to next step: If the specified state
- If not the specified state
- Engine Running
- Transmission in Park
- Verify the scan tool parameter: Transmission ISS = Engine SpeedNOTE:
The value should change smoothly and gradually as the engine speed is increased and decreased.
- If the value does not change
Refer to: Circuit/System Testing
- Go to next step: If the value changes
- If the value does not change
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Verify the DTC does not set.
- If the DTC sets
Refer to: Circuit/System Testing
- Go to next step: If the DTC is not set
- If the DTC sets
- All OK.