Bushing And Mating Shaft Inspection

WARNING: This page is about a different car, the 2018 Chevrolet Suburban 3500 HD. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Proper bushing and corresponding mating shaft inspection should be performed before replacing the bushing, shaft, and in some cases, the component which houses the bushing. Thoroughly clean and dry the bushing and shaft surfaces before inspecting for damage.

Any of the following bushing conditions require replacement of the bushing and/or housing:

Discoloration due to heat distress
Misalignment or displacement of bushing as a result of spinning in housing
Medium to heavy scoring that can be easily detected with fingernail. Light scoring is a normal condition.
Debris embedded into the bushing lining material
Obvious damage, including excessive and uneven wear
Excessive polishing. Minor polishing of the bushing is an indication of normal wear and does not require replacement.

Any of the following conditions require replacement of the bushing's mating shaft:

Discoloration due to heat distress
Rough surface finish that can be easily detected with finger
Obvious shaft abnormalities, including warping or uneven surfaces
Obvious damage or cracking