LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2018 >> Escalade Base, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 2 (Engine Mechanical - 6.0L (L96)) >> Repair Instructions - On Vehicle >> Oil Level Indicator Tube Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2018 Chevrolet Suburban 3500 HD. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Oil Level Indicator, Tube, Bolt And O-Ring Seal
    GM3631308Courtesy of GENERAL MOTORS COMPANY
  1. Remove the oil level indicator (1).
  2. Remove the oil level indicator tube bolt (2).
  3. Remove the oil level indicator tube (3) from the engine block.
    4. NOTE:

    The O-ring seal may be reused if not cut or damaged.

  4. Inspect the O-ring seal for cuts or damage.
  5. Remove the O-ring seal (4) from the tube, if required.
scientia non olet · About LEMON Manuals